- 9V center negative power required (No internal battery connections)

- Less than 10mA current drawy
- Also capable of handling 18V for higher headroom
- Hand wired using through hole construction, no SMD parts
- In-house powder coated and screen printed enclosures
- 125B enclosure 4.77" x 2.6" x 1.39" (121.1mm x 66mm x 35.3mm)

- True bypass 3PDT switching
- Quality Neutrik input and output jacks
- Real Alpha pots with dust seals
- Free shipping anywhere in the USA

Bearclaw Fuzz

This silicon fuzz pedal dishes out plenty of saturation with inspiration from the vintage Colorsound 1 Knob Fuzzbox. The bias of this circuit has been tweaked to get a large amount of gain, while still retaining a low noise floor. With the Body knob all the way up, you will have a huge low end, enough to fatten up even the lowest output vintage single coil pickups. As the Body knob is rolled back, the bass input is decreased and the fuzz can pull off retro overdrive and drive tones, without being overly harsh like other silicon-based circuits. Work your guitar volume back to clean up the tone and then wind it open for the assault. The Input control acts just like the volume control on your guitar, allowing you to preset the signal going into the fuzz so you don't have to fool with your guitar's volume knob every time you turn it on. The Bearclaw Fuzz is nastiness in the best possible way. 

Now Only $119 USD